Subject:METALTECH2010
METALTECH2010 was exhibited in Kuala Lumpur Malaysia on 5th - 9th. May. 2010.
There many Taiwanese Machine were exhibited.
Date: 08. May. 2010
Subject:METALTECH2010
METALTECH2010 was exhibited in Kuala Lumpur Malaysia on 5th - 9th. May. 2010.
There many Taiwanese Machine were exhibited.
| I went to PWTC on 8th May. Not so many customers compared to another exhibition. But there crowded around the latest machines. | ||
 |
 |
 |
 |
 |
 |
Start the tour in Tool Show.
 |
 |
 |
| These conventional machines are possible to use enough. | Also good machines. | Tools made in Taiwan are possible to use for Industry, right? |
 |
 |
 |
| The price of this milling machine made in Taiwan is only JPY600,000. | This plane grinder is made in Taiwan perfectly, including the slide
rail. I think good manufacturing, right? |
Linear Gide and Ball Screw are very interesting. Material is from
German and Japan, and machining is in Taiwan. Price is around half of Japan made and life time is around 70% Dimension is perfectly same as Japan made and possible to change. This parts are used in one Japan brand made in Taiwan. Possible to use for maintenance, right? |
 |
 |
 |
| This is famous brand Vertical Machining Center made in Taiwan. Bearing and Linear Guide are Japan made, and NC Rotary Table and Controller are also Japan made. Fabric and Cover are made in Taiwan. Important parts for accuracy are still made in Japan. Price is around 70% of Japan made. |
This machine is Japan brand but made in Taiwan Parts assembly is same as Taiwan made. Price is around 80% of Japan made. |
This machine is made in India under technical support from EU. Bearing and Linear Guide is from EU made. Controller is Japan Brand. Price is a little cheaper than Taiwan made. |
Taiwan machines are progressing rapidly.
After some years, many Machining Center from Taiwan will be used
for automobile production in South East Asia.